Answer Posted / gova
Bus fault level was calculated using symmetrical method.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
What are the two major types of control system?
Atwhat condition reverse power relay will act?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
what & how to check the lightning arrester
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what are factors to be consider to design a HT & LT motor?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What is kirchoff ’s current law (kcl)?
A jet of fluid strikes a plate What was the force required to counter it?
can u give me a brief idea about power line carrier communication ??
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
how to calculate the conductor size for certain KV transmission line and distribution line?