what is the differnce between high impedance relay and low
impedance relay




Answers were Sorted based on User's Feedback



what is the differnce between high impedance relay and low impedance relay..

Answer / chander, ak

High impedance principle means that protective relay has a
such a large series impedance that even the largest through
fault current occuring during transient condition does not
start an un-necessary relay operation.High impedance relay
is one in which all CTs must have the same ratios. it is
employed in The differential protection of generators, bus
bars, motors and reactors.
Low impedance relays do not have any additional series
impedances and are usually employed for transformers
differential protection.

Is This Answer Correct ?    12 Yes 8 No

what is the differnce between high impedance relay and low impedance relay..

Answer / rsn

i am also search answer

Is This Answer Correct ?    4 Yes 4 No

what is the differnce between high impedance relay and low impedance relay..

Answer / grv

Find the perfect answer herehttps://www.linkedin.com/grp/post/1801744-5938258109569986560

Is This Answer Correct ?    0 Yes 0 No




what is the differnce between high impedance relay and low impedance relay..

Answer / premsns

Boss , may i know the relay operation in which transients
occurred in Low impedance protection

Is This Answer Correct ?    1 Yes 4 No

Post New Answer



More Electrical Engineering Interview Questions

house wiring - series wiring or parallel wiring

4 Answers  


While testing a ZCT what parameters have to check or measure?

0 Answers   Indian Railways,


What is gain margin?

0 Answers  


as we know that N=120f/P speed of an im can be controled only through changing no if poles, can we control by changing the frequncy????

7 Answers   JSW,


Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha

0 Answers  






What is voltage ratio of a transformer?

0 Answers  


why in the three pin plug all 3 pins are cutted ?

0 Answers  


HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory

0 Answers  


why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?

0 Answers  


how to find out 3 phase complex power in per unit in unbalanced system?

0 Answers  


name the types of insulatter?

5 Answers  


in one substation we have two power transformers of 100mva,75mva capacity.statoin load is155mva.how much each tranformers share the load????

6 Answers   TNEB Tamil Nadu Electricity Board,






Categories
  • Civil Engineering Interview Questions Civil Engineering (5069)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4437)
  • Electrical Engineering Interview Questions Electrical Engineering (16573)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1091)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (258)
  • Instrumentation Interview Questions Instrumentation (2984)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (96)
  • Marine Engineering Interview Questions Marine Engineering (122)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1376)