where this neutral connection goes after returning from the
load(home ,factory,industries).Is it grounded at the
transformer side or atthe generator side .If it is grounded
then we also ground the earth connection.is there any
problem with this.
Answer Posted / beaconguru@gmail.com
Transformer secondary side neutral is earthed.if unbalanced load condition residual return current only goes to earth it's a safest one actually.In basic ground is the very low impedance path compare to your earth rod.current always choose low resistive path.so it's not possible to return feed current flow from ground to equipment.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the mechanical safety of DG ?
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
Pleae send me last 5 years of Question book about RRB chennai.
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
Is any generator is developed which is operated with out diesal or other expensive source?
What is meant by sag?
how oti and wti connections are different from each other?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
What is the current carrying capacity of 35sq.mm flexible cable?
one electromagnet is called
What is the cut-off rate?
what is current check gurd relay?
What happen when change order of CT in GIS feeder?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?