Answer / sai

1ton=3.5kw

Answer / chandru_williams

I would like to say that , if the 1 ton which is mentioned
here refers to refregiration or AC, then it is given as

1Tr = 1.5 KW.

This is the general thumb rule.

Answer / b.sudhahar bagavathiappan

I have think 1 ton = 1.2 kw, HVAC design pepoles are using
that value for constrction works

Answer / avnish sharma

1 ton = 12000 BTU/hr

and to convert BTU/hr to horsepower,

12,000 * 0.0003929 = 4.715 hp

therefore 1 ton = 4.715*.746 = 3.5 KW

Answer / sukhdev

3.5kw

Answer / shaik saleem

1TR = 1.2 TO 1.5 KW (ELECTRICAL)

Answer / myo

a standard ton of refrigeration is 12,000 BTU/h = 200
BTU/min ≈ 3,517 W

Answer / gulshan goyal

1 ton is a unit defined for air conditioner.it is the heat
energy consumed by 1000kg(1 ton) ice at 0 degree tempreture
to melt in 24 hours. hence it the latent heat for 1 ton ice
to change its phase to water.

Answer / murali

1 TR refers 1 Ton(US) of refrigeration capacity. It is the
heat required to melt 1 Ton (907. 185 kg) per day of ice at
0 Deg C to water at 0 Deg C. This is basically the latent
heat of fusion of ice.

Latent heat of fusion of ice @ 0 deg C = 80 Kcals / kg
For melting 907.185 Kg ice / day, the heat required is
72575 Kcals / day or 3024 Kcals / hr or 3.516 KJ / sec.

Since 1 KJ / sec = 1 Kw, 3.516 KJ / sec = 3.516 Kw.

Answer / lava kumar.v

1 ton = 3.5 kw
1 kw = 0.2843 RT

Is there any standard guidelines/Criteria to design NGR/NGT.?

0 Answers  

How i can calculate the cable size for given load,there is any formula,for 3 phase and single phase

2 Answers   Prescient Technologies,

difference between high and low impedance BUS BAR relay??

0 Answers  

The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is

0 Answers   Caterpillar,

How magnetic balance test of single phase transformer is done,Especially in ESP transformer rectifier set.

2 Answers   Bhel,

being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give

0 Answers  

What is the exact load current needed for a place which has 100nos of bulb of each 100w?

2 Answers  

How line capacitance & line inductance varies with increase in height tower.

0 Answers  

why transformer rating is expressed in kva.

4 Answers   Electrosteel, L&T,

Why power factor is arising in electrical circuit, is it possible to eliminate from the circuit, why

2 Answers  

At what load maximum effiecency will be obtained Distribution transformer and Genarating transformer Pls clarify?

4 Answers  

why breaker closing coil gets burnt if supply is continously provided to it.

1 Answers   TATA,