when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....

0 Answers  

---

If two induction motors A and B are identical except that the air-gap motor 'A' is 50 % greater than that of motor 'B', then

2 Answers   Lanco,

---

What is the simplest formula to calculate the rotor diameter of a synchronous generator?

0 Answers   PEI,

---

how current is reverse from its normal direction during the fault?

0 Answers   HGF,

---

can we use optical fibre to electrical power transmission ?

1 Answers  

---

What are all the problems occured while ac generator running in leading power factor at full load condition?

1 Answers  

---

For 7.5kw star delta starter how to calculate 1. Mccb rating 2. Contactor rating 3. Over load relay rating

1 Answers   L&T, MAHINDRA,

---

In my 3 phase 4 wire electrical system N to earth voltage is 0.08 is it ok What is standard for it ?

1 Answers   Kay Bee,

---

WHAT IS THE USE OF TERTIARY WINDING IN A STAR/DELTA TRANSFORMER ?

3 Answers  

---

1.why ACB is not connected in HT side what Happens? 2.how much voltage maintained in ACB breaker? 3.OLTC is connected in primary side in case secondary side connected what happened?

3 Answers   L&T,

---

As a good company employee, can you report your supervisor to the company management if he or she is going against the company interest in his or her actions?

1 Answers   MAHINDRA,

---

What Normal(Tangent) towers and Tension(Cut-point) Towers?

1 Answers   ABB, BGR Energy, NTPC, Powermec,

---