How much current does a motor take in no load condition?
Answers were Sorted based on User's Feedback
Answer / b.suiyaprakash
in no load it takes less than 30 to 20% of full load current
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / sunks prasad
motor will take the at no load is 1/3 rd of full load
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / yuvarajan
20% of full load current, that is mass of the rotor and
depends on xl perameter in the stator coil.
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / chinmaya
1.5 times of the full load current of the motor.
Is This Answer Correct ? | 0 Yes | 10 No |
What is the funstion of buscoplure in LT panel? which propouse using the buscoplre
What are the different methodes for calculating the short circuit Current?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is earth pit , how we can measured it, what earth rods reference
difference between a four point starter and three point starter
To determine the Healthiness of Insulation we will be performing Dielectric tests i.e Insulation Resistance test, Partial Discharge test,Switching Impulse, Lightning impulse, Tan Delta test ...etc why we required to perform this many test, why cant we do only one test. for Transformer, CT's
what is diffrenance between ACB and Isolator
Electrical Design specifications
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Can you explain about TEE protection scheme?
why transformer comes only in standard rating like 11kv,33kv,66kv....and not like 33.33kv and so on?
A 3PH MOTOR RUNNING IN NORMAL CONDITION AND ITS AMPERE ALSO UNDER ITS FULL LOAD CURRENT,ITS CABLE RATINGS ALSO HIGER THN ITS CAPACITY,BUT ITS CABLE GETTING ABNORMAL HEAT(NOT TOO HOT)WHY ITS GETTING HOT LIK THIS