Interested to Buy Any Domain ? << Click Here >> for more details...
How much current does a motor take in no load condition?
- 6 Answers
- 9992 Views
- I also Faced
- E-Mail Answers
Answer Posted / yuvarajan
20% of full load current, that is mass of the rotor and
depends on xl perameter in the stator coil.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what irequirment need to be followed when working on live equipment
what is different between relay and plc?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
how to calculate cable size in diffrent loads?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
block diagram of 2 ups system connected in hot stand by mode?
What kind of preventive maintenance are there for transformer?
What is speed mode?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
How does HT work & Voltage required?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
