Answer / nd.palanivel

No rotating magnetic field is generated and hence the motor
will not rotate, instead a break is applied on the rotor for
a sort period. Depends on the magnitude of the DC supply and
the DC resistance of the coil, heat will be generated on the
coil. Coil will burn if the supply is applied continuously.

Answer / bikash chandra pal

Earlier reply is OK, some more elaboration given below
No rotating magnetic field is generated and hence the motor
will not rotate,
No back EMF will be generated,
reactance(XL)will not come effect as frequency is "ZERO",
Rotor impedance will be remain isolated from equivalant ckt
of stator.
Only resistance of stator ckt(which is very low) will be
there. Hence stator current will be very high,Motor will
burn.

Answer / lollu

motor is not run.heat may be generated.

Answer / sunil g parit

it draws the excess current motor in not rorating due to
rorating field id not generating,it bocomes hot Or failure
of motor

Answer / rajan raju

WHEN DC SUPPLY IS GIVEN TO THE AC INDUCTION MOTOR THERE IS
NO PRESENCE OF ROTATING MAGNETIC FIELD SO MATOR DOES NOT
ROTATE BUT THE FIELD WINDING IS LESS RESISTIVITY SO HIGH
CURRENT WILL BE DROWN AND DUE TO THE PRESENCE OF HIGH
CURRENT MOTOR WILL MAY BE BURNED

Answer / pranav priyadarshi

actually when dc supply is given to ac machine there will generate const field due to which rotor won't rotate, and also stator draws large current due to which i^2*r losses is more and hence more heat is generate ,due to which machine may burnt out......

Answer / yazan saada

it will be a sync motor not induction

Answer / arivu

sparks are produced
and efficiency also low

Answer / c.rajakumar deee.,be.,

Motor will draw more current .
A hissing sound and a dampering will occur in motor it may
damage the motor severly and results in coil burn also

what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving side???

2 Answers  

why insulators are colured in brown only?

3 Answers   Transco,

What is center gravity load in substation?

0 Answers  

how air lock will be removed from generators, how it happens?

1 Answers   ABC Engineering,

Due to ferranti effect which power increases at the receiving end?active power or reactive power?

5 Answers  

Difference between SHORT CIRCUIT and an OVERLOAD ?

1 Answers  

flurescent bulb rating is to 230v,50HZ.now flurescent connected 230v,25HZ.whether nreduced frequency will affect the glowing properties of flurescent.

6 Answers  

Dear sir,how should i set the relay in star delta starter..say ex i am having 4ohp motor,,wht should be the relay setting...?

4 Answers  

When motor stater and roter air gap do big then what will moter.

3 Answers   Intas,

how to design the heater in temperature control unit to heat 50KL of water?

0 Answers   SunMax,

what are the 6 terminals of the motor plss give me in details

5 Answers   Siemens,

What will happen to transformer if we gave 5HZ input instead of 50/60Hz??? explain with reason

2 Answers