what is the reason for drop in freq. from 50 hz at
generating side to 49.8 ,49.6 etc.at receiving side???

Answers were Sorted based on User's Feedback



what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving s..

Answer / venkatesh s.r

I think, generating side generator speed was not constant.

Frequency is directly proportional to speed.

Is This Answer Correct ?    4 Yes 1 No

what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving s..

Answer / k.prakashchandra

It is not possible to have different frequencies at
generator and tail end.

Is This Answer Correct ?    0 Yes 4 No

Post New Answer

More Electrical Engineering Interview Questions

In a 3 phase system a neutral exists so that any unbalanced currents can flow through it towards earth.... but a phase demands a particular current as per the load attached to it....then where does the extra current come from the goes in the neutral??....I mean in an unbalanced system a phase demands a current as per its load attached....then where does the unbalanced current come from??

1 Answers  


refrigeration cycle?

1 Answers   MAHINDRA, Shapoorji Pallonji Group(SPCL),


why characteristics of overcurrent relay is time-->psm instead of time-->current?

0 Answers   ABB,


I am getting differential earth fault in my transformer realy , i have checked all its CT & control wiring but do not get fault, Please help

6 Answers  


How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?

0 Answers   TCL,






how capacitor buield up the voltage

3 Answers  


List examples of voltage source?

0 Answers  


Construction of Diesel generator set?

1 Answers  


what do u mean by starting torque? how it should be for a good motor? what is the relation between starting torque and power factor? What is the relation between efficiency and starting torque?

2 Answers  


what about GD square and its important for motor design?

0 Answers   Innovis, MNC,


What is expand formation of AYFY cable

2 Answers   HP,


In a circuit a capacitor (paper capacitor ) was burned due to over voltage in this case can we replace that type cappacitor with other tye capacitor ?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)