how to design the heater in
temperature control unit to heat 50KL
of water?
No Answer is Posted For this Question
Be the First to Post Answer
How the oil level of the Buchholz Relay come down.
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
what are the merits and demerits of synchronous motor over an induction motor...??
If excitation will increase, then what will be the effect on power factor? Will it decrease or increase?
our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage
how can we select the rating of Load break switch that is connected to the primary protection of 200 kva 11kv/415v distribution transformer?? step by step calculated answr pls...thnk.u
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
how much resistence in proper earthing?
What is delta stare switch?
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
what is units of resistance
Before i went to bed my master bathroom lights were working fine. At 2 am, when I went to use the lights, none of them were working. The outlets throughout the bathroom work, but the lights and fan above the toilet don't. I have two panels of switches. The one panel has four switches. One of the switches turns on the hall light, and that works. The other three are to other lights, and they don't. The other panel has three switches. One of those is to the fan, and the other is to a light above the toilet. The other is a to light that is also on that other panel. I tried the breakers, and the one that turns off the outlets, marked for the bathrooom, turns on and off the outlets. None seemed to be tripped. I checked the lightbulbs, and they are fine. Please help
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)