why we are calculating the capacitance between
phase(conductor line)and ground in transmission line?why
cant we calculate capacitance between the phase and the
nuetral line?if so what is procedure.
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
how much current carry a 3-1/2 core of 100mm size cable.explain it with solution
last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the primary of delta transformer. we get 33A at the primary of the R phase star end. but we get 380A at both R an B in delta side. how and why?
If 110 volts ac is mixed up ith 12 volts dc what will be the resultant voltage and what is the wave form?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
can i use ups power as a raw power for another ups
Explain the advantages and disadvantages of thermal power plant?
what are the available sizes of pin type terminal lugs in the market today?
How to calculate the NGR value for a 2.7MVA Transfomer, 11KV system where the fault current has to be limited to 50A?
Can we manually synchronize two DG sets of same ratings manually without using speed biasing ? If yes then how?
What is the output voltage of a DG set.
as ac supply is given 2 the transformer why it doesnot depends upon powerfactor????
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)