Interested to Buy Any Domain ? << Click Here >> for more details...
Questions :-
HR-
Q.1 about yourself & family background ?
Q.2 Why u choose Power sector as ur carrier starting not any
other sector ??
Q. 3 What think abt NTPC ?
Techincal Questions:-
Q.1 about Vocational Training……What u did , see the main
equipments….etc
Q.2 Why a transformer Noise during its running condition ?
Q.3 about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ? ……..some discussion type ?
Q.4 What is relation between transmission lines &
Communication lines ?
Q.5 Which Machine u will prefer to use at a place where
flammable gases are coming out & why ?
Q.6 how fault in an electric system is detected & hw
protection of equipments is done ?
Q.7 Why we didn’t feel electric shock in an electric train ??
Q.8 Anything u want to ask from us ??
- 44 Answers
- 47218 Views
- Akona Engineering, Bhel, BSES, Cranex, DRDO, JCB, NTPC, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / vinod
Pls send related ans for me.my email id.
vinothkumar.eee28@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / sanjeev
plz send me the ans.....
my email id is tokas.sanjeev@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / irfan
plz send me answer plz plz
my mail id is
irfan_irfan81@yahoo.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / jitender
I also need the answers.Pls send it at
jeet_lovemeet@yahoo.com
pls do it soon
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / mousumi
please send the answers of these questions to my email id...
mousumip05@gmail.com
for dis i'll be grateful to you
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / nagur sharif.shaik
Q6:fault in an electric system is detected by using switchyard control systems. relays.then we have to operate a circuit breaker.......
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / abhilash
Please sen me the answers for above questions . My Mail Id :
abhilashchandamalla007@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
what is mean by drives?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what should be the minimum rating for using HT Motors?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
What are the advantages of the three-phase motor over single phase motor?
To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?
how to arrange the generator protection ansi 48 (loss of phase?)
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
Diode is active or passive element?
what is mean by restructuring power system?
Normally the starter used to reduce the starting current.but the dol starter do not it,so why we use it?
What is mean by discrimination of circuit breaker ?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
