Answer / k.prakashchandra

To measure with multimeter, one wire has to be taken through
the meter . You can use clip-on /clamp meter which are
available for DC also.

The cable area of cross section is 185 sq mm. How to convert this to the diameter.

7 Answers   Syscon,

---

why the LED of my electrical meter glows even after the line has gone. what actually the reason?

3 Answers  

---

what is mean by PIR in circuitbreaker and give me detail of that?

0 Answers  

---

Why does a TV set have two pin plug whereas the moniter of a computer has three pin plug? Isn't the earthing protection required for the TV set

2 Answers  

---

what are the basic concept to design a out door Substation?

1 Answers  

---

Generally we denote power in 'p',voltage in 'v'but why can't we denote current in 'c' instead of I.

4 Answers   Bhel,

---

why are you use the crgo core lamination in transformer

6 Answers  

---

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?

6 Answers   Bhel,

---

3 ph motor connected in star delta starter. when we start the motor it run in star but when in is going in delta it trips the main incoming supply. why?

3 Answers   Bajaj Hindusthan,

---

What is the significance of %Z in case of transformer?

1 Answers  

---

what is the major difference between LIBBP & HIBBP.. which one is most preferable..

0 Answers   ABB,

---

I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF

0 Answers  

---