which motor is suitable for traction? why?
Answers were Sorted based on User's Feedback
Answer / bhupesh
DC series motor, always!!
because of its high stating torque and speed control..
But now a days, like in Delhi metro squirrel cage induction
motor is used becoz of its compact design, less maintenance
and regenerative current system.
also some improvements are made for better speed control..
| Is This Answer Correct ? | 9 Yes | 6 No |
Answer / hemlata
Series wound dc motor due to it has low resistance field and armature winding (according to ohms low I=V/R) advantage high current magnetic field inside the motor strong,produce high torque (turning force)
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / himabindu
D.C. Series motor since it has a high starting torque
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / fulchand mahato
(a) →high starting torque.
(b)→better speed control.
(c)→low maitanance cost.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / surender kumar
Series motors are widely being used in traction systems, due to good starting torque ,speed controlling quality.
In general terms series motors are starting on load and performing great in compare to rest motors.
Now induction motors are also being apply in traction with SCR it is recent development.
| Is This Answer Correct ? | 0 Yes | 0 No |
11 KV Power cable end earth connection insulation got burned wht is the reson pl give the resons
How to increase home power factor? Can we connect capacitor directly? How to select capacity of capacitor?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
Are we do it in single transformer with dual primary as 11 KV and 33 KV and constant output as 415 Volts?.
What is the name of oil which is used in transformer?
if the diameter of a conductor is 'R' then what is the distance between two bundle conductor in a phase?
what is the difference in MCB, MCCB, RCCB, ELCB, & MPCB (motor protection circuit bracker)
12 Answers Afcons, Bhel, CIHSR, DCS, IOCL, L&T, Lupin, Siemens,
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
Showing results for capital, machinery, stock,wages, carriage in words, salaries, factory rent, repairs, fuel and power, buildings, debtors, sales, purchases, creditors, return outwords, return inwords, drawings, discount allowed, discount receivable, office expenses, bills payable, bills receivable, cash in hand, cash at bank, office rent comes under debit or credit
1.Is there any difference between terminologies,HT-HV <- LV? 2.What is the highest transmission voltage level in india?
what are symmetrical and non symmetrical components in electrical installation.
An 11kv system consisting of an underground cable to a sub station about 300 meters away was shut down for about 10 hrs. On energising, it tripped off on earth fault about 10---20 mins later 6 times but since than it is not tripping.its already 3 weeks now. The SPAJ was found to be fine. what could be the cause.No test had been done to determine the cause of the trippings till now because of demand.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)