Answer / rk sharma

In generator there two type of m/c
1. Mechanical (Prime Mover)
2. Electrical (Alternator)

When a running/rotated prime mover coupled to alternator,
mechanical engery converted into electrical energy by the
electrical machine.

Answer / ramanjaneyulu

IT IS A MACHINE WHICH CONVERTS MECHANICAL ENERGY IN TO
ELECTRICAL ENERGY IT WORKS ON THE PRINCIPLE OF FARADAYS
LAWS OF ELECTROMAGNETIC INDUCTION

Answer / krishna

Generator is the one which gives voltage as its output, by
having mechanical input.

For Eg: When the water falls on the panes fitted on the
shaft of motor the the force of the water results the shaft
to move and hence we have the current as its output.

( coil rotating in a magnetic field results in a current)

Answer / murugesh.r

Generator its convertes mechanical energy into electrical energy it is the working principle of faradays law of electromegnetic induction

deisel generators all elcetical calculation formule's

1 Answers  

---

In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.

0 Answers  

---

advantages & Disadvantages of Solar power system?

2 Answers  

---

which is the best, A/C DRIVES or D/C DRIVES for cranes,...... ...and why......?

2 Answers   Alstom,

---

A resistance of 50 kΩ has a conductance of:(a) 20S(b) 0.02S(c) 0.02 mS(d) 20 kS

1 Answers  

---

How to calculate the 2500 Kva Transformer losses Primary 11KV Secondary 415volts

1 Answers   Laurus,

---

what are factors to be consider to design a HT & LT motor?

0 Answers  

---

how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)

0 Answers   Suzlon,

---

An 11kv system consisting of an underground cable to a sub station about 300 meters away was shut down for about 10 hrs. On energising, it tripped off on earth fault about 10---20 mins later 6 times but since than it is not tripping.its already 3 weeks now. The SPAJ was found to be fine. what could be the cause.No test had been done to determine the cause of the trippings till now because of demand.

2 Answers  

---

What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?

0 Answers  

---

what is the working principle of ceiling fan and table fan?

10 Answers   ABC, Tata Steel Limited,

---

which protection function should measure RMS value of current&DFT value of current?

0 Answers  

---