Answer / pallab jyoti phukon

high dielectric strength,good mechanical properties,they
should not deteoriate with age.

Answer / kcsahoo88

high resistivity,more heat capacity

Define end float in a motor?

0 Answers  

---

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

0 Answers  

---

which INDIAN STANDERD in Mention the earth test value?

1 Answers  

---

Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?

0 Answers   Madina Group,

---

What is the permissable nutral current of three phase system as per IS standards?

0 Answers  

---

What is the difference between type1 and type2 relay protection co-ordination for motor feeders

0 Answers   DAE,

---

what is the value of combined earthing in general electrical circiut?

0 Answers   Cathtect Engineering,

---

Why cant we connect the motor output to generator and then generator output to motor ?

4 Answers  

---

WHAT IS LOAD CELL

0 Answers   AP, TATA,

---

what do you mean by partial discharge in cable

1 Answers  

---

WHAT IS THE USE OF ANTIPUMPING CONTACTOR IN HT BREAKERS

8 Answers  

---

Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

0 Answers   Danieli,

---