Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sharath
Rotor and stator field of a synchronous generator run at same speed, if due to any disturbance , mismatch in the speed of rotor and stator occurs then pole slipping is initiated.
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
What is the difference between a verilog task and a verilog function?
Can you explain about TEE protection scheme?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
how to calculate the formula of cable size if motor kw is given
What is the maximum percentage voltage drop (vd%)for a motor control center
What is oscillator circuit?
ult of expression 'document.FrmQF.myem
How earthing of switchgear system to be done.
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
Write down the brushes of a de machine.
How many sprinklers should be in one pipe line?
