what will be happen if we apply D.C supply to the
transformer
Answers were Sorted based on User's Feedback
Answer / deepankar
If a constant dc is
applied then primary of
transformer will burn
out.
However if a variable
dc is applied as
obtained from rectifier
without filter then it will
work in same fashion
as on ac.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / monalisa jena
If the primary of a transformer is connected to a d.c
supply,the primary will draw a steady current,hence
prodocue constant flux.consequently no back emf ll be
produced.The primary ll draw excessive current due to flow
of low resistance of the primary.The result is that the
primary eill overheat and burn out the transformer.
| Is This Answer Correct ? | 1 Yes | 3 No |
Answer / samit
A transient spike will apear at secondary and then will
disapear.
| Is This Answer Correct ? | 10 Yes | 14 No |
Answer / kishore
WHEN YOU APPLY AC SUPPLY TO TRANSFORMER AS IT FLOW
ALTERNATIVELY UP N DOWN LIKE JUMPING HENCE IT WILL JUMP
FROM PRIMARY WINDING TO SECONDARY WINDING BUT IN CASE OF DC
SUPPLY AS IT GOES IN A STRAIGHT LINE IT BANG WITH PRIMARY
WINDING LIKE A HEADON COLLISION AND BREAK IT ........
IF U GIVE THIS ANS I'M SURE U'LL QUALIFY IN ANY INTERVIEW
| Is This Answer Correct ? | 14 Yes | 39 No |
Why AC current leads voltage in capacitor and how?
What is rms value wher it is used??????????
how much distance is required for earth pit to earth pit in substation???
Three phase star connected PT transformer primary side one phase fuse is blown what will be the output in secondary side(Secondary side also three phase star connected)
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
What is inductance?
back emf of motor at the time of starting ?
how can we decide where we have to DYn11 or other vector group transformer
4 Answers BSL, Knight Frank, Security Printing and Minting Corporation of India Limited,
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
explain working principle of earth leakage relay
0 Answers Divis Laboratories, SMIORE,
What motor is used in ceiling fans and what motor is used in table fan.? why table fan is costlier than ceiling fan?
what is load shedding
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)