Answer / dale bergemann

RMS is Root Mean Squared. If you have a sinewave baseline Peak value of 1, your Peak to Peak (P-P) is 2. Then your Average value of 0.637 and finally an RMS value of 0.707. P-P is the value of the energy that is doing work. It inherently is void of transients/harmonics distortion. If you use a multimeter that measures in true RMS, it will have greater accuracy than that of an average reading meter, and usually cost more money. I've posted the ratios of the various units, to explain how to calculate it would take more time and space.

What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?

0 Answers  

---

what is the name of oil used in transformer

11 Answers   Energy Pack, Genco,

---

Is phase preventer require when overload relay is there

1 Answers  

---

What is Negative Potential Bias

0 Answers   TATA,

---

What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?

0 Answers  

---

what will happen if there is a voltage leakage or current leakage in an electrical train

0 Answers  

---

why core losses are affected with change in voltege in transformer?

1 Answers   HCL,

---

How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?

0 Answers  

---

Why the capacitor are connected in Delta(Three Phase) for power factor improvement ?

5 Answers   Hero Honda,

---

How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.

0 Answers  

---

Which type of alternator used in power station?

2 Answers  

---

what is the difference between electrical & electronics?

4 Answers   JSW,

---