why dc power can not be used in transformer?

Question Posted / akrishnan24

33 Answers
69667 Views
GE, Sail, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why dc power can not be used in transformer?..

Answer / sunil mehta

In transformer, if we give DC Power to transformer then
very small emf is induced in secondary side as very small
magnetic field generated through DC supply. But if we used
AC supply then we get enough voltage on secondary side
which is our desired quantity.

Is This Answer Correct ?

1 Yes

4 No

why dc power can not be used in transformer?..

Answer / abid ali khattak

Because of Meutial.induction.and sign wave frequency
induction.

Is This Answer Correct ?

14 Yes

38 No

why dc power can not be used in transformer?..

Answer / victorvgp

Dc transformers are also available in markets

Is This Answer Correct ?

8 Yes

35 No

Post New Answer

More Electrical Engineering Interview Questions

Define protection core in CTs Ex. 5P10, 5P20 etc.

1 Answers HPL,

In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is

0 Answers Caterpillar,

Explain why machinery used on a.c supply is usually rated in KVA instead of KW?

10 Answers EEE, Mtandt,

what is the use of the puls transformer in UPS & how it works???????????

0 Answers

Can a transformer designed for a particular voltage and frequency rating be used for different set of mentioned ratings? Assume that the winding does not get burnt because of overheating at higher voltage. If yes, then under which constraint it is possible?

1 Answers

Can we use HRC fuse inplace of semi conductor fuse ? What are difference between them?

3 Answers

Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz

0 Answers

DG SET BLOCK DIGRAM

0 Answers L&T,

Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.

0 Answers GE,

how we can convert 3 phase to single phase without using any transformer

8 Answers

define bilateral network and unilateral network? give an example.

3 Answers ABB,

do we need NGR panel when the output of the genset is LV but after that it is step up to 22 kv. condition is 12 genset 400v are operating in parallel.

1 Answers

For more Electrical Engineering Interview Questions Click Here