Answer / srizdhar

Volt between netural and erath should be zore as per electrical law,but in site or aney applecation it should belwo 130 micro volts, why means erathings stays rooting parrlally to power cables.

Answer / k s yadav

Regarding Q11, whenever get more voltage across neutral and
earth that will imbalance the phase voltage with respect to
neutral as well as phase also cause conneted load or
sensitive devices might be got faulty or do the wrong
operation as per induction theory.Therefore earth leakage
voltage should be zero in ideal condition but in practicle
should be maintained less than 1 voltage in organisation.

Answer / raz

1- Voltage between phase & earth less then 3V.
2- Voltage between phase & neutral is 230v.

Answer / rajasekaran.raman

what suresh said is correct only for second and third ,but
1st how could you say that value?

Answer / abdul gafar

most of the 3-phase stepdown distribution transformers
manufactured in india are 11KV/433v. assuming that the the
voltages are measured at LT Side of the transformer and
earthing is perfect ( i.e. when meggered with 500v megger
the resistance offered by the earth is zero)then,

earth to neutral= Zero
any one Phase to earth= 250V
& any one Phase to neutral=250

(the value 250 is arrived from the fact that the voltage
from phase to Phase is equal to 1.732 times that of the
voltage between phase to neutral)

Answer / john

Phase to earth should be 0 volt. But up to 6 Volts
permisssable.

Answer / hariram

voltage between earth & neutral is always nil.

On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?

0 Answers   TNEB Tamil Nadu Electricity Board,

i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance

0 Answers   Vedanta,

why conductors of low tensile strength 1)produce greater sag and 2)can not be used for larger spans

1 Answers  

what will happen if ac power supply is given to the rotor of an alternator

1 Answers   Goldman Sachs,

Why the transmision line are 11,33,63,132kv?

10 Answers   Power Grid,

why we use bare wire in high tension power instead of using insulated wire?

2 Answers  

What is Surge Capacitor? Why it is use in Generator Circuit Breaker?

0 Answers   TCS,

In 3 phase induction motor even with low Voltage it reaches nearly it's rated speed why? (for example instead of 400V it reaches with 250V)

2 Answers  

what type of cables exsisting in the world and how many types

9 Answers   Alstom,

22kV HT incoming should be 3 phase or 4 phase? why is it not 4 phase?

1 Answers  

which type of starter is suitable for single phase motor ?

11 Answers   IOCL,

5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

0 Answers