Answer / sahayam

Dear sir,
Please give the answer my question
I have one blower its impeller dia 1200mm
impeller width -115mm
shaft dia 90mm
weight of impeller - 300kgs
impeller rotating speed -1800 Rpm
Blower motor 125Hp/4p(belt drives)
Blower pressure - 700 mmWG
now! what is the Gd square valve
what is the axial loads

Answer / gyan guru

gd2 is the value which is meant to check that whether a
given motor will mingle with an impeller or not. Its a
sought of age of fan and motor.

Technically , it tells us about the measure of the ability
of the motor to attain its a rated speed from rest.

This is calculated with the formula
4 x m x r2

m = mass of the impeller

r = radius of gyration

r shall be 0.4 times the radius of impeller

I hope its sought of clear now

How ElCB tripping if Neutral touch with ground

4 Answers   Sanmar,

---

What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.

0 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

what is the purpose of vector group in a transformer ? if 2 tranaformers r connected in parallel the vector group is same or not? for parallel operation 2 transformers of different manufacturers maintain same vector group or not?

3 Answers   Orchid,

---

why and how fault current flows through ground?

1 Answers  

---

1. name the relay for protecting transformer 2. Current Transformer 3. potential Transformer

1 Answers  

---

Conventionally, capacitors are considered to generate reactive power and inductors to consume it,how??????

1 Answers  

---

difference between EMVT, PT & CVT ?

9 Answers  

---

if current required for triggering thyristor at -30 degrees(temp) is 80 mA, what is the current required at 60 degrees

1 Answers  

---

if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.

0 Answers  

---

on which power factor synchronous motor run

2 Answers   Bhel,

---

What are the advantages and disadvantages of open loop control system?

0 Answers  

---

working function importance of mdc meter

0 Answers  

---