Answer / wasim

By inserting current limiting reactor in series with line.

In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.

0 Answers  

---

a induction motar has 30-35% exciting current at no load but in transformer it is only 2-3% ofbrated current why any reason?

1 Answers   century,

---

What is meant by vector group

0 Answers   GPSC Gujarat Public Service Commission, VA Tech Wabag,

---

how to calculate units consumption for a 12 hp motor /hr.

0 Answers  

---

Why the Motor takes High Current in Starting time?

5 Answers  

---

whate is the meaning of balance/unbalance,in stabilizers type

0 Answers   TCS,

---

Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.

0 Answers  

---

What is the relationship between voltage,current & frequency?

0 Answers  

---

What percentage netural current is in netural depend upon the phase current

1 Answers  

---

What is the difference between MCCB, ACB & VCB

7 Answers  

---

State the formula for overall efficiency of thermal power station

0 Answers  

---

Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?

6 Answers  

---