why we step down voltage level from 33kv to 11kv and 11kv
to 415v.Instead we can step down voltage from 33kv to 415v
directly using single transformer.
Answers were Sorted based on User's Feedback
Answer / sathish.su
Normally substation is far away from city or villages. So
if we are transmit 415 v supply then the current rating and
copper loss and conductor thickness everything is high. If
we transmit 11Kv supply means the losses and current rating
and conductor size will be less. So we step down to 11 kv
first then step down at 415v.
Is This Answer Correct ? | 11 Yes | 22 No |
Answer / devang
if we conside 33kv/11kv &11kv/450v the energy transfer is
same as by 33kv/450v so current level is same for both
Is This Answer Correct ? | 12 Yes | 44 No |
What are the conditions to be satisfied for parallel operation of dc generators?
how to find total current when kva is 30.4 given ? should we use root 3 (1.732) in the formula?
why transformers are rated in KVA
Since phi is the angular displacement between V & I, then why we use phi in power triangle ie. when showing active, reactive & apperent power in triangular manner & if it is ok then where is V & I in the triangle.
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
how a circuit breakers work at fault condition .plz give a specified answer.
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What is the difference between AC Drives and DC Drives?
14 Answers College School Exams Tests, La-Gajjar Machineries, LG, Schneider, SMEL,
What is voltage in two phase?
do we convert single phase line to three phase at minimum cost?
why nutral and earthing wire connect with each other in main panel board.
What is sensitivity of a measurement?