Answer / basavaraj patil

At constant temperature the current flowing in an electric
ckt is directly propotional to the applied voltage and
inversly propotional to resistance of the ckt.

i.e.. V=IR or R=V/I or I=v/r

Answer / ganesh, gescom, hospet

Ohm's law states that the current through a conductor
between two points is directly proportional to the potential
difference or voltage across the two points, and inversely
proportional to the resistance between them.

Answer / mahantesh.s.k

Ohms law state that in any closed ckt the current is
drictly proposenly to the votage applyed inversely
proposenly to the resistence of the ckt temp is same.

V= I X R I = V/R

Answer / krishna

At constant temperature current flowing in an electri ckt
is directly proportional to thev applied voltage and
inversly proportional to the resistance of the ckt

Answer / veeranjaneyulu

V=IR
I=V\R

Answer / ketal

there is no change of phyisical state of conductor so the
ratio R is constant.R=V/i.

Answer / sivananda samantara

in a close circuit voltage is direct propotional to
current and in this same circuit with a same tempreature
it indirect propotional to its resistance.
v=ir

Answer / ajax

Voltage is directly proportional to Current, i.e.,

V ∞ I
V = (R) I

i.e.,
V = IR

Where V->Voltage, I->Current and R->Ohm's law Constant
(Called by the name "Resistance" with unit as ohm(Ω))

Difference between low impedance and high impedance Restricted Earth Fault

0 Answers  

what will happen if transformer given dc input

5 Answers  

What is generator

1 Answers   Mytrah Energy,

What happens if 25 Hz frequency is applied for 400/200,50 Hz single phase Transformer.Will Voltage increase ?

2 Answers   Bhel, Dawlance, IBM,

what is motor?

2 Answers   UIU,

can anibody tel me on what basis the transformer vector groups are determined????

1 Answers  

Why the wave trap is put in Y phse only in switchyard?why not in other phases?

1 Answers   IAG Automation, REL,

why transformer is rated in KVA ?

5 Answers  

if i am in front of transmission line how to know that current direction without any equipment

0 Answers  

difference bewteen reverse current and alternating current

0 Answers   ABB,

what is the standard duration after failure EB power

0 Answers  

how u calculate ups battery backup

2 Answers