Answer / Jitendra Kumar Ray

Calibrating a vibration probe in the field typically involves the following steps:n1. Disconnect the probe from the measurement device.n2. Use a standardized calibration source to simulate vibration signals of known frequency and amplitude.n3. Compare the measured response with the expected response from the calibration source.n4. Adjust the probe or the measurement device as necessary to correct any discrepancies.n5. Repeat the process for different frequencies and amplitudes.n6. Document the results and verify that the probe is within acceptable tolerances.

if drum level is low what is interlock? i mean we put interlock to fd fan or id fan ?

4 Answers  

---

how to work MIL contol valve posistioner ?

1 Answers   ABB,

---

What is difference between Ionization heat and bimetallic heat

1 Answers   KOC,

---

CAN YOU USE MOVING COIL METER FOR MEASURING A.C?

2 Answers   DVC,

---

what is the function of a zener diode ?

2 Answers   Honeywell,

---

how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc

1 Answers  

---

should I use Hydrostatic Pressure Transmitter for measurement of DENSITY of filled tank ? If YES then please explain how.

2 Answers   HPCL,

---

What is flow ,level, pressure transmitter ?and units?

2 Answers  

---

What is the main difference between Cavitation and Flashing?

2 Answers  

---

Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?

1 Answers  

---

what is input and output cards of plc needs to be hot swappable mean

1 Answers  

---

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

1 Answers  

---