How to Calibrate Vibration Probe (Axial, Redial) in field
- 1 Answers
- 1220 Views
- I also Faced
- E-Mail Answers
Answer Posted / Jitendra Kumar Ray
Calibrating a vibration probe in the field typically involves the following steps:n1. Disconnect the probe from the measurement device.n2. Use a standardized calibration source to simulate vibration signals of known frequency and amplitude.n3. Compare the measured response with the expected response from the calibration source.n4. Adjust the probe or the measurement device as necessary to correct any discrepancies.n5. Repeat the process for different frequencies and amplitudes.n6. Document the results and verify that the probe is within acceptable tolerances.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
principle of dead weight tester ?
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
sir, give me placement papers and interview quistion of birla group company of copper.
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
send me last 5 years questions asked in rrb chennai, for section engineer
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
