Answer / viral

it is mixture of lime, alumina, silica, iron and ferrite.

Answer / saravanan

it is mixture of lime stone and some other chemicals,and it
is used for the constractive purpose

Answer / sumit

cement is mainly manufactured from lime stone and silica and
alumina .the main quality of delay in adhesivness is due to
gypsum.

Answer / gadilingappa k

Its mixture of calcium silicat and aluminate

Answer / raja

it is a mixture of limestone,sand,clay,mortor and used for
constructive purpose

Answer / mohammed raffi

CEMENT-(A mixture used to bond materials like Rock or stone
etc.,)Technically it is a Mixture of Clinker,Limestone(or)
additives and Gypsum. The Percentage of mixture may vary
w.r.t. quality. The main raw material is Clinker. Gypsum is
added to increase the setting time of Cement mortor when
cement is mixed with Water.

Answer / harshitanaidu

it is a mixture of limestone,sand,clay,mortor and used for
constructive purpose

Answer / ramakant kanojiya

cement is a binder, a substance that sets a7 hardess
indepently & canbind other material together. It consist of
mainly lime & ferrite, alumina, silica etc.

Answer / vaseemzehak

Cement is a binding material which made by argilaceous and calcareous material.There are two process of cement making:
1-wet process
2-dry process
Most popular to make cement is dry process.

Answer / tejaswini m.s

It is a fine mineral powder manufactured with very precise
process which is manufactured by using raw materials which
is used for binding purpose

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage.

1 Answers   FGI, OPS,

Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2

0 Answers   PCSB,

why does make gain margin and phase margin on same plot.?

0 Answers  

Why is negative feedback invariably preferred in closed loop system?

0 Answers  

Why 50hz and 60hz frequencies are used by the world, why they are not taking 55hz?

3 Answers  

at the time of starting back emf of a motor is zero.so how can it will start to run??

1 Answers  

HOW TO CALCULATE THE VT SIZING?

0 Answers   L&T,

explain about the electrification in the Indian Railways? ie., how the power is taken and used to drive the train? explain with the block diagram??

1 Answers  

How can we check ELCB trip current sensitivity How can we check earth resistance value

2 Answers  

TO CALCULATE THE RESISTANCE OF GRR OF HT MOTOR 400KW WHEREAS STATOR VOLTAGE 6.6KV AND ROTOR VOLTAGE 705V AND ROTOR CURRENT IS 346A.

0 Answers   Bhel, NTPC,

how to decide the panel size like MDB ,SMDB PANEL SIZES

0 Answers  

whydoes the p.f of diesel generator always be 0.8 explain how will you determine the shortcircuit capacity of network

1 Answers   Dalkia,