Answer / Gunjan Kumar

A turbine meter works by measuring the rotational speed of a rotor, which is driven by the flowing fluid. The rotor has turbine blades that are designed to turn at a rate proportional to the volume flow rate of the fluid. As the fluid passes through the meter, it spins the turbine rotor, causing an electrical signal to be generated due to the rotation. This electrical signal can then be converted into a flow rate reading.

Which is your favourite subject & explain any one topic of it.

1 Answers   L&T,

---

what is the difference between Feedback controller and Feed forward controller. and when it is to be used.

3 Answers  

---

In most process, speed of motor controlled by control system with a reference pot . Now if i start & it becomes uncontrollable, i.e.gets directly start & stop after certain time.Then which reasons can make such problem? can motor may be faulty?how?

3 Answers   Siemens,

---

what is difference between pressure,flow and level control valve.

3 Answers  

---

why we are using negative range like -750 to 0 mmwc in closed tank?and what is the reason can you explain clear?

2 Answers   Aarvi Encon,

---

how the transmitter send MA?

1 Answers  

---

A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.

1 Answers  

---

difference between span and range

3 Answers   IOCL,

---

i have height of stem drum level 1000mm.how i calculate the DP transmitter

2 Answers  

---

what's the criteria of using over range protector when installing Pressure Gauge

1 Answers  

---

How does milli volt is created in themocouple?

2 Answers   Jaypee,

---

When a timer is placed in RS Logix 5000 with preset value less than its scan time it is malfunctioning. i.e., if the preset is set to 30ms still the timer TT bit is counting till 150ms(its scan time). Any solution for the problem?

2 Answers   Balco,

---