A DP transmitter is used to measure the level of an open tank. The drain line

A DP transmitter is used to measure the level of an open tank.
The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator.
If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?

Question Posted / davidvara.mercy@gmail.com

1 Answers
1498 Views
I also Faced
E-Mail Answers

A DP transmitter is used to measure the level of an open tank. The drain line of the tank is conne..

Answer / Sonu Singh

To wire a DP transmitter and control valve with a HART communicator, follow these steps:
1. Connect the pressure tap from the bottom of the open tank to the DP transmitter's input.
2. Connect the transmitter output to the control valve input.
3. Wire the HART communicator to the DP transmitter according to the manufacturer's instructions.
4. Configure the transmitter and valve using the HART communicator, setting up the desired proportional relationship between tank level and control valve opening.
5. To find the %opening of the control valve at 60% level of the tank, we can use the following formula:n Control Valve Opening = (Tank Level - Tank Minimum Level) / (Tank Maximum Level - Tank Minimum Level) * (Valve Maximum Opening - Valve Minimum Opening) + Valve Minimum Opening.nAssuming the tank has a maximum level of 100%, a minimum level of 10%, and the valve opens from 0% to 100% as the tank level changes, we can calculate the control valve opening at 60% level:n Control Valve Opening = (60 - 10) / (100 - 10) * (100 - 0) + 0 = 40%

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

transmitter in 3 connection +,-,And test mode so how Use To Test Mode

1 Answers Essar,

How to convertion 100 m3/hr to mmH2O or to Kg/cm2?

0 Answers

How to calibrate the control valve.

1 Answers

what is a half wave, full wave, and bridge rectifer.

1 Answers Takreer,

what is solenoid valve?

1 Answers

What is the main difference between Cavitation and Flashing?

2 Answers

HOW TO CALIBRATE A DRUM LEVEL TRANSMITTER

2 Answers

is fan is a transducer or inverse transducer?

5 Answers

For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.

1 Answers

Technician A says the brake warning light is connected into both the parking and service brake systems. Technician B says the brake warning light will come ON only if the service brake system fails. Who is correct?

2 Answers

How to do calibration of magnetic flowmeter

1 Answers Kharafi National,

What is a PID controller and how can it to applied to our everyday life?

4 Answers

For more Instrumentation Interview Questions Click Here