Answer / pooja

use latch after pushbutton and then output
or
give memory in or to pushbutton and then output.

Answer / bppatel

you can use this with holding contact

Answer / nirmalya basu

If u r in programming just connect the input without latch
to the output that input will act as a toggle switch or u
can use OSR in the programming it helps u to energies and
deenergise an output with a single button.

What is the difference between instrument earthing and normal earthing? and why is it necessary to do so?

3 Answers   Atul,

---

What is purpose of shield wire?

1 Answers   IFFCO,

---

How to convertion 100 m3/hr to mmH2O or to Kg/cm2?

0 Answers  

---

what is the square root flow transmitter formulla ?

2 Answers  

---

How does milli volt is created in themocouple?

2 Answers   Jaypee,

---

why is an oxygen sensor used in a boiler stack

2 Answers   HCL,

---

how u calculate ai/di/ao/do capacity in ur dcs?

1 Answers  

---

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers  

---

what barrier is used in process industry.

3 Answers   ADMA OPCO, Process Industries,

---

What is hp & mp seperator .& what is its working principle ?

0 Answers  

---

Why the industry's standard current standards are from 4mA to 20mA,not from 0mA or any other range?

3 Answers  

---

define SIMULATION a and what is the need of it

3 Answers   Siemens,

---