how to difference between the HT&LT cables



how to difference between the HT&LT cables..

Answer / a.elumalai

HT cable high tension of operating to high voltage location of industrial for purpose of 11kv,33kv A conductor or conductors designed to carry electricity or an electrical signal over large distances with minimum losses and distortion 12/20(24)kv Aluminium cable insulation copper tape screen steel wire armor PVC sheath Industrial use very strong the cable sheath something any fault automatically trip the transformer smoking redacts very less
LT cable low tension voltage consumers construction mall single phase line 230v three phase line 430v used for LT cable low sheath the core termination

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

How to measure power in 2 or 4 or n phase circuit? Please give me a formula.

0 Answers  


What is meant by Reactor in power system and what are the uses?

11 Answers   EEE,


What is voltage in two phase?

7 Answers   ABB, SSG,


What is quadrantal symmetry?

0 Answers  


What is the Difference between Power Swing and Out of Step?

1 Answers  






When Neutral exceeds or equals the phase current in both single phase * three phase system?

1 Answers  


for compensate 315mh inductance ,how many capaciance required?

1 Answers   Mitsubishi,


it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?

0 Answers   TATA,


What the capacitor Current formula?, For 1 KVAr how amps its required? for using the KVAr for boosting the PF Design Calculation.( Eg: for 30 KVAr required how many KW?)

17 Answers   Alstom, Call Centre, EDC, HCL, Procon Engineers,


HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS

0 Answers  


If i want to build 230kv substation what are the equipments to be installed?

7 Answers  


What should be the setting of an earth fault relay.

2 Answers   HP,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)