What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
No Answer is Posted For this Question
Be the First to Post Answer
If two induction motors A and B are identical except that the air-gap motor 'A' is 50 % greater than that of motor 'B', then
induction 3 phase motor terminal connection
what is the best electrical system i.e substation sytem of 11kv/.433kv for a township. if township have 300nos substation of 11kv. we have to go G.O.D.O. fuse unit or Compact Substation Unit. please reply Asap.
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
Why use only DC supply to charge batteries why not AC Supply??
Differentiate between induced emf and self inductance?
WHAT IS RMU & HOW IT WORK,IT USEFUL FOR HT OT LT POWER DISTRIBUTION MAUFACTUERE IN INDIA.
how the inductor will work on dc supply?whether it will work or not?
In a 11KV 3phase system do you need to earth both sides of the cable?
which relay is used for both detection & correction?(there is only one relay)
how to select the surge suppresor for the 33 KV supply and what will be the rating, selection guide
what type of load we can give to motor shaft?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)