Answer / latheef

Reliable.Less fault.

What is the Difference Between choke & ballast

3 Answers   ABB, ICS Integrated Computer Solutions,

---

What is partial discharge in power cable?

1 Answers  

---

Why diversity factor are applied to the load?

2 Answers  

---

Why power factor is arising in electrical circuit, is it possible to eliminate from the circuit, why

2 Answers  

---

how will you determine the short circuit capacity of a network

3 Answers   Dalkia,

---

Relation in between KWH & KVAH for Electrical consumption unit & how we can relate if KWH is lower than KVAH

11 Answers   Deepak Fertilisers, Torrent Pharma,

---

Will a 230VAC motor run OK at 208VAC.

7 Answers  

---

on 22.03.2015 at 17:15hrs Y phase 66kV class Power Trf-2 Current transformer has flashed over and oil came out. The failed CT has been replaced on 24.03.2015 at 13:15hrs and the Trf has been charged in presence of RT Hassan after conducting the pre-commissioning tests. On the same day at 17:00hrs the commissioned CT has again flashed over and immediately the Trf  has been isolated from power supply. It is confirmed the secondary is not opened and checked the earth integrity and is found ok. Here what would be the reason for the CT failure? 

2 Answers  

---

pls tell us AC plant are how do work and parts name with picture

1 Answers   Mukand,

---

What is the selection & Designing procedure for DG/Transformer

4 Answers   Crompton Greaves, Sterling, TATA,

---

How much is the starting current for HPMV lamps. How many lamps can u wire in a circuit

1 Answers   Technip,

---

in 31.5 mva power transformer how to set of wti and oti?

1 Answers   HMEL,

---