Answer / devesh mishra

selection & designing depends on the LOAD,space,use
provided by the consumer.

Answer / ramarpandi

rating

Answer / r.baskar

Selection of transformers = Maximum Connected load *
loadutility factor of the industry(0.75 is the thumb rule)

For DG Maximum capacity of the Motor being started at
DOL*2..

Am i right ..?PLs clarify ....

R.Baskar

Answer / mahender sharma

Transformer & DG Selection is depend upon Area & Load.

i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply

1 Answers  

---

why ac can not be stored?

5 Answers  

---

How much load can give on 1600 kva transformer 11kv/440

5 Answers  

---

which types of tests are required after commissioning of 6.6 kva tranformer?

3 Answers   Reliance,

---

what are the specifications we must look at to select a relay for any capacity motor?

0 Answers  

---

---

Short circuit current of 2500 KVA 11/0.415 KV transformer both Secondary and primary side. best regards. Ali

1 Answers  

---

what happens to the speed of a DC series motor when series field winding is removed?

8 Answers  

---

What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?

0 Answers  

---

what is rocking arrangement in arc heating

0 Answers  

---

What is a parabolic signal?

0 Answers  

---

what is the use of the circle diagram

2 Answers  

---

why is a power transformer used only occasionally?it is used to step up at generating stations?and that needs to be done all day long !!!!!!!

0 Answers  

---