Answer / sudipt jena

Partial discharges often occurs near the entering of cable into a panel or electrical machines.Because at this position, the cable is stiffly bended which results stress in the insulation i.e. XLPE. And as the time passes insulation degrades leading to passing of some electrical charges from conductor to the earthed parts of the panel or machine. A humming sound is also created and is called partial discharge.

how will you find out the fuse failure by remote operation?

1 Answers  

---

what is the difference between megger and earth resister ??

0 Answers   HMPL,

---

how to maintain frenquncy with syncronising sub-station for distribution

0 Answers   Suzlon,

---

Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??

0 Answers  

---

How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance

0 Answers  

---

hw to find transformer is in normal position? whether its in charged condition or not? except humming sound?

9 Answers   ABB,

---

Can transformer develop three phase power from a single phase source?

12 Answers   ONGC,

---

WTA used cb?

0 Answers   Tagros,

---

In three phase, phase to phase voltage is 440 Volts, but the three phase motors are designed for 415 Volt, 50 hz, why

1 Answers   Shree Ram, Shriram, Sri Ram,

---

why the the phase transformer's nuetral has been grounded

2 Answers  

---

difference between ordinary MCCB & Motorised MCCB

4 Answers  

---

If two transformers same rating(11KV / 440V)connected in the same primary line(11KV), can we connect(bus coupler) secondary side directly or need a synchronization????

3 Answers  

---