Answer / hassan

I start=10 * In
for example
500 W HPMV lamp In =2.08 A & Istart=21 A

How many lamps ....?
This depends on the wire surface.
2.5 mm2 >>> 6 lamps
1.5 mm2 >>>> 4 lamps

Why transformer rating in kVA not in kW?

5 Answers   ABB,

---

how can i increase the excitation on full load running engine??

1 Answers  

---

can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...

0 Answers   GKB,

---

What is the difference between EARTH & NEUTRAL?

13 Answers   L&T,

---

What is an 86-P or an 86-A trip

0 Answers  

---

How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?

3 Answers  

---

what is mean by busbar and what is the difference between busbar,transmissionline,feeder,distribution line

0 Answers  

---

without name plate detail of blower how we can find out the HP & Rpm ? the input voltage is 230v single phase

1 Answers  

---

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

What is a fuse? How does it work? What are materials used?

0 Answers  

---

why do power factor in the three phase induction motor increases with the load ???.

3 Answers   Jindal,

---

how meger function

0 Answers  

---