Answer / mrssa

in contactor when its coil supplied with dc ..the position of its contacts changed n.o to close and n.c to open
contactor is connecting device
c.b is protective device when current increase than rated c.b trip

Answer / k.prakashchandra

Basic difference - CB trips when the trip coil is energized, in csae of contactor , the hold coil is de- energized to trip .

Answer / sheikh

there are major difference b/w contactor and circuit breaker. contactor has moveable contacts and fixed contacts
while Circuit breaker only have fixed contacts. contactor have become energized when it,s coil would be got supply or been energized. however these are 2 different things.
Ampacity may be same both of equipment.

Does power factor vary with speed?If yes, how?If not, why?

4 Answers   Genco,

---

what law motor works?

3 Answers  

---

At what speed 1 HP motor can run an electric car of weighing 400 kg?

0 Answers  

---

In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.

0 Answers   Hyatt,

---

How do you change an AC motor to DC? why there is only 50 Hz frequency in india & not other?

4 Answers   BSF, TATA,

---

I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????

0 Answers  

---

if the back emf eqution for dc motor EB=(QPNZ/60A) THEN what is the value of A for PMDC MOTOR OR how can dicide the value of "A"

2 Answers   BSL,

---

Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......

4 Answers   Hindustan Unilever Limited,

---

how is the incoming cable size calculated for a given current rating of a panel??

0 Answers  

---

If there is no problem with the electronic circuit and regulator then why the motor start rotating at low value of regulator with full speed both at laod and no load??? and if my judgement of circuit is wrong then what is your openion?

1 Answers  

---

what is the suitable voltage of transmission line to transmit 10000w power through 250 km. (a)11kv (b)33kv (c)66kv (d)132kv ]and please tell me whats the logic behind it

7 Answers   ONGC,

---

I have calculated load for an office building which is 1200 KW as all the load is single phase therefore its 1200 kw single phase. Now i have to design Transformer and Generator for this load Please kindly give me exact answer that how much capacity of Three Phase Transformer and Three Phase Generator is required for this load.

3 Answers  

---