Answer / Satish Kumar Gupta

The calibration procedure for a Transweigh make weigh feeder typically involves the following steps: 1. Zeroing the feeder to ensure that it registers zero when empty. 2. Adding known weights of material and verifying that the feeder correctly records these weights. 3. Adjusting any necessary parameters to ensure accurate readings. 4. Repeating steps 2 and 3 multiple times to verify consistency in readings. Consult the manufacturer's manual for specific instructions.

What is cut off relay? And why use in PLC and DCS?

1 Answers  

---

why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.

1 Answers  

---

how to callibrate a new i/p converter

7 Answers   TATA,

---

what is the zero elevation and zero supresstion in level measurement, how can use it?

2 Answers   GAIL,

---

what is the difference between hub and switch?

6 Answers  

---

In turbine what does term CDP, NH, HSSOC means.

1 Answers   Takreer,

---

what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration

1 Answers  

---

what is function of vibration, and how is it work, explain with difination

1 Answers   Bapco Bahrain Petroleum Company,

---

what are the steps to commissioning a DCS system?

2 Answers   BGR Energy,

---

How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible

1 Answers  

---

why are use only 4 to 20ma. signal.

9 Answers   Otsuka,

---

In close vessel/ drum why we use d.p. transmitter of -ve range i.e. (-)500 to 0 mmwc.

2 Answers   IMECO, Voltech,

---