Answer / uddipan sarkar

first of all mass flow transmitters are 4-wire tx. In 4-
wire tx we give a seperate source to power up the Tx and
from its ma terminal we take the 4-20 ma current signal.its
not a loop powered transmitter like the 2 wire.
you should first clear ur concepts about 2-wire tx and 4-
wire tx

when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.

7 Answers  

---

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PLease suggest me....

6 Answers  

---

given a processor batch of 1000 resistors moving on the conveyor belting in a large factory. the resistors is value at 10k ohms each but when the resistors reach the quality control, some of the resistor has been rejected caused by failure in manufacturing.the high quality measurement is used to determine the failure. describe the instrumentation terminology in measurement of a system above with explaining the important in:- -reliability -sensitivity -repeatability -precision -range -resolution -linearity -hysteresis -error -accuracy (answer must related to the scenario above)

0 Answers  

---

what is the importance of CV in the control valves? how it is calculated?

0 Answers  

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

How to do calibration of magnetic flowmeter

1 Answers   Kharafi National,

---

what is the basic working principle of I/P and Positioner in any control valve.

12 Answers   Essar, Visa Steel,

---

What is the Difference between E/P Positioner and I/P positioner in a control valve? In which applications the respective positioners are used in?

18 Answers   ADCO,

---

what is flow equation of kg/hr to m3/hr

2 Answers   Philips,

---

What is rated capacity in Control valve

3 Answers  

---

what is the analog input , analog output , digital output, digital input geven to the MSSV , CBD, IBD , START UP VENT , BOILER FEED PUMP , AOP, CEP , ETC

1 Answers   Bharat Biotech, TATA,

---

can we connect instrument earth pit to electrical earth pit, if not why?

2 Answers  

---