Answer / suryanaik02@gmail.com

Dry and clean oil gives BDV results, better than the oil with moisture content and other conducting impurities. Minimum breakdown voltage of transformer oil or dielectric strength of transformer oil at which this oil can safely be used in transformer, is considered as 30 KV.

Answer / asma

No it is considered as 26kv(bdv of oil) according to high voltage engineering laboratory

Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB

0 Answers  

---

Differnce between Analog & Digital

1 Answers  

---

my self i am raghu working as tech.. in my college the maximum demand is 211 kva presently we are using 12kva capacitors the target power factor is .95 so what capacity of capacitor banks should i install

2 Answers  

---

If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????

0 Answers  

---

What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?

0 Answers   Eprosys Engineering Consultants,

---

1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?

0 Answers   IBM, Kirloskar,

---

what will be the difference on output when 3phase I.M. is given a delta or star supply?

3 Answers  

---

What is Hi-Pot Test for Grid Station HV Equipments?

2 Answers   Siemens,

---

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

what is fuction static switch in ups and tell me use parts name and fucion

3 Answers   Dalkia,

---

What is difference between YNyn0 and YNyn ??

0 Answers  

---

pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )

0 Answers   Bhel, IBM,

---