why did the BDV test in transformer?
- 2 Answers
- 2643 Views
- Jindal Steel and Power, I also Faced
- E-Mail Answers
Answer Posted / asma
No it is considered as 26kv(bdv of oil) according to high voltage engineering laboratory
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
Define characteristics impedance?
What is the significance of integral controller and derivative controller in a pid controller?
What are the special cables required for explosion proof wiring?
what is transistors comprised of?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
distribution is maximum done by a)radial b)network c) parallel d)b & c
1.what is the reason for transformer and lightning arrester blast in 33kv system
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
will there be any problem by recovering slip from single phase induction motors?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
what are the safety measures of induction motor?
what are pilot cells
Circuit diagram of tube light without starter using electrical choke
