Answer / vinoth

IR means Insulation Resistance. basically IR value need is ( Rated KV+1 ) Mohm.
For eg if motor rated voltage is 11Kv then we need IR value has 12Mohm.

Minimum 1Mohm is sufficient to start LT motors.

For HT Motor- ( Rated KV +1)Mohm

it is very suffient to start motors

Mention what are the different colors on wires indicates?

0 Answers  

---

what is post close & pre close of trip circuit supervision relay in circuit breaker control scheme?

2 Answers   ABB, NEK, Power,

---

what is high tension ? specify the range?

3 Answers  

---

What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers  

---

why in america the supply frequency is applied as 60 HZ. but in india we use 50 HZ.

1 Answers   Elcom International, HCL, NTPC, OMC,

---

why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?

0 Answers   OGDCL,

---

we all know that in transformer, voltage and current are inversely related i.e. Vp/Vs= Is/Ip....so in standard CT..we have a ratio of 200/5...that means our voltage should increase by ratio of 40..althoug that is not the case...because that requires high insulation level.and pratically not feasible......can anybody clarify my ques.......thanx

2 Answers  

---

What happen when increese more than 50HZ fequincy.

5 Answers  

---

What is the universal motor?

0 Answers  

---

High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?

0 Answers   NTPC,

---

what is the difference between MCCB and SFU in terms of their application?

2 Answers   Secure Meters, Tata Teleservices,

---

can we start a 6.6kv ht motor with 415 lt supply

1 Answers  

---