An Rod of 25mm in dia, is bend and made into a circle Ring with outer dia 200mm,

An Rod of 25mm in dia, is bend and made into a circle Ring with outer dia 200mm, then what ll be the length of rod required?

Question Posted / sutheesh

Answers were Sorted based on User's Feedback

An Rod of 25mm in dia, is bend and made into a circle Ring with outer dia 200mm, then what ll be the..

Answer / dayanand sonawane

200-25 = 175

PI()X 175= 549.77

Is This Answer Correct ?

4 Yes

4 No

An Rod of 25mm in dia, is bend and made into a circle Ring with outer dia 200mm, then what ll be the..

length is irrespective of the rod dia.
Therefore, length = Pi*D
ie= Pi*200=628

Is This Answer Correct ?

0 Yes

0 No

More Mechanical Engineering Interview Questions

Define the term latent heat.

CATIA:VARIATON IN SIZE AND PATTEREN

what's the difference between moment of inertia and mass moment of inertia?

sir, I am applied RRB chennai,MMV(mechanical),Pls mail 2006,2007 & 2008 years solved question papers.My Mail jrks@rediffmail.com

i want technical interview qestion?

bel question

Which factors influence the type of fracture in failure of a material ?

What parameters to be reported when we send lubricating oil for shore analysis?

pls send me rechnical test paper of reliance with answers for last five years??

What is the difference between an isometric and an orthographic drawing?

Will going from a 3 tap to a 6 tap increase water pressure?

Is pipe round because it provides the least area to volume ratio?

For more Mechanical Engineering Interview Questions Click Here