Answer / rajasekaran dme

1/8 INCH = 3.1750 MM

Answer / guest

3.175

Answer / dharmender

3.175

Answer / shudrabhavik

obviously 3.1750..
As 1 inch = 25.4 mm
1/8 inch = 3.1750 mm..

Answer / p

3.175 mm

Answer / rajesh vora

3.175MM

Answer / ankit sojitra

3.17 mm

Answer / ashish

10mm

Answer / sanju

1.25 mm

Answer / guest

1.25

what is the function of platern water wall in a boiler? and difference between with ordinary water wall?

0 Answers  

Why is stress considered important in a shaft?

0 Answers  

the compression ratio of petrol engine is always less than c.r. of deseal engine why?

3 Answers  

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

best tip to increase fuel efficiency with a high powered engine?

1 Answers  

From a group of 7 men and 6 women, five persons are to be selected to form a committee so that at least 3 men are there on the committee. In how many ways can it be done? A. 564 B. 645 C. 735 D. 756 E. None of these

1 Answers  

Compare the prandtl numbers of Air, water and Liquid metal. If prandtl number is more what do you understand?

0 Answers  

hi every one, i want to make a coal grinder to mil 3 or 4 tons of coal dust per hour . if you guys help me with photos or some tecnical drawings that would be very kind of you.

0 Answers  

is it necessory to use heat exchanger in case of water cooled chillers & cooling towers?????

3 Answers  

Can we integrate the C programming with Pro-e (modelling software)through application program?

0 Answers  

why direction of angular acceleration is not find out by right hand rule?

0 Answers  

i am a mechanical engg.8th sem student.i want to know the syllabus and criteria,previous question paper set of section engg(RLY).please send it to my email id.pleaseeeeeeeeeeeeeeeeeeeeeee

0 Answers