If NO contact of relay gets supply from other sources or other part of circuit and at a time relay coil activates,then current will flow in which direction & will it cause to damage relay??



If NO contact of relay gets supply from other sources or other part of circuit and at a time relay c..

Answer / rakesh

current will flow from no to common, and there will not any damage with relay coil.

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

What are the causes of electrical faults?

1 Answers  


sir, is there any ratio,this much of A.C volt is equal to D.C voltage

3 Answers  


what is the permissible bend in the LT& HT CABLES.

2 Answers  


how you configure motorvision relay (L&T make)from DCS

1 Answers   Ispat,


what is the differents and advantages of Electro magnetics relay and static relay ? what is the numerical relay ? advatages?......

7 Answers   CAT, L&T, TCS,


What is the "IS" for Rising Main?

1 Answers   APTransco, NTPC,


How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me

1 Answers  


In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.

1 Answers  


what is the function of impulse relay

1 Answers  


why neutral wire don't shock?

9 Answers  


iam interesting to design the control panel for 3 phase pump motors by controling single phase switches.iam plan to use fuse,contactor & relay for motor protection .how can i select the voltage & amps rating for fuse,contactor & relay plz guide me .if anybody clarify my doubt means it will more helpful for my future .

1 Answers  


if two transformers are parallel & both have fault short ckt. impedance of 50KA in each case will it increase or decrease show example?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)