Answer / arul abraham

Since the diameter of the steel rod compared to the area of concrete in a section is negligible
i.e a beam may have size of 200mmX300mm but the diameter of the steel rod is 12mm(Assume) which is negligible when compared with 200mm or 300 mm.

Answer / raja maqbool ( q.s ) acc

The Quantity of Steel being small no deduction is made for steel from Volume of concrete.
Binding wire is not taken separately but included in item of R.C.C work.
Ref:- Estimated & Costing in Civil Engineering (B.N. DUTTA)

Answer / k

Consider a 200x200 column with 4 nos of 20 mm bars.
Total volume of steel: 3.14x0.02x0.02=0.01256
Total volume of concrete= 0.04-0.01256=0.038744
Almost same as 0.04

List out the potential risk factors for workers on the construction site?

0 Answers  

---

Describe why concrete must be compacted after it is poured?

2 Answers  

---

how do you intend to overcome such challenges?

1 Answers   Savanna Energy,

---

How much material is required for constructing a 2 Lane 2Km rigid pavement road

0 Answers   HCC,

---

how calculate the bearing from two coordinates?

0 Answers   DPTL, HPPCL Himachal Pradesh Power Corporation Limited,

---

Factor of safety for steel should be based on its yield stress or its ultimate stress and factor of safety for concrete should be based on its ultimate stress or its yield stress?

2 Answers   NTPC,

---

in construction feild make the column rods are uneven ( e.g 1 column we have 6 nos of bars that 6 nos of bars are varrious level- 1 bar 10';2 bars 9';3 bars 8') what is resion to put different level if difference are required or not?

3 Answers  

---

Please send the graphical comparision Viscosity vs temp. for Penetration grade, Viscosity grade & CRMB.

1 Answers  

---

what is a pretension and post tension with an example

1 Answers  

---

how to prepare the bar bending schedule for a given rcc material?It will be more helpful if you explain me with an example?

1 Answers  

---

1.DIFFERENCE BETWEEN NOMINAL MIX AND DESIGN MIX? 2.WHAT IS MEANT BY STRUCTURAL DESIGN? 3.IN STAAD WHY WE RELEASE MOMENT TO A MEMBER? 4.ON WHAT BASIS PARTIAL FACTOR OF SAFETY ARE DECIDE?FROM THE LOAD COMBINATION? 5.WHY WE PROVIDE EXTRA BAR & DEVELOPEMENT LENGTH AT TOP? 6.FULL FORM OF SPT & SMB? 7.WHAT IS MEANT BY ITP IN A CONSTRUCTION PROJECT? 8.WHAT IS LEAST COUNT OF THEODOLITE SURVEY? 9.WHAT ARE THE CAUSES OF FAILURE OF FOUNDATIONS AND REMEDIAL MEASURES? 10.WHAT ARE THE VALUES OF COMPRESSIVE STRENGTH? 11.STEEL CALCULATION FOR FOOTING,BEAM & SLAB? 12.WHAT IS MEANT BY GANTRY GIRDER? 13.IN SITE HOW WE CAN IDENTIFY THE ONE WAY, TWO WAY SLAB? 14.DIFFERENCE BETWEEN ANCHORAGE LENGTH & DEVELOPEMENT LENGTH? 15.BEARING CAPACITY OF STEEL SHUTTERING?LOAD CARRYING FOR SHUTTERING?

3 Answers  

---

How to testing voids of filled aggregate in bitumen mix design

0 Answers  

---