Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...


How can I check the quality of
sand,brick,and aggregateat site without
using any labouratory test?



How can I check the quality of sand,brick,and aggregateat site without using any labouratory tes..

Answer / pranav panchal

For sand: -


Take it in ur hand if you find more clay content in the sand then its not good for concrete work, sand must be free from grass and other impurities likes clay clots, roots, round stones.

For bricks:-

Take 2 bricks and stuck them if you get sound like ring bell then its good.

take 5 samples and leave them one by one from the height of the 1 mt, bricks must not be broken nor get cracked.


For aggregate:-

Must not be more flaky, rounded, must have angular corners and must be free from the dust

Is This Answer Correct ?    13 Yes 1 No

Post New Answer

More Civil Engineering Interview Questions

I what know about life time of frp tank plz explain about it specifications & other details

0 Answers  


how do we calculate quantity of cement sand and aggregates in 1m3 of m20 m25 grade concrete?

0 Answers   Alfanar, Ancon, RAZ,


How to calculate the quantity of water in cement mortar eg. CM 1:3?

2 Answers   FuRyu,


Materials datas like cement sand steel brick 20&40mm aggregate required per sqft of building?

2 Answers  


What is the concepts of buoyancy & effect of weight distribution on floating bodies?

1 Answers  






how to take quantity in triangle section for calculating tender purpose

1 Answers  


why is M30 grade Concrete use for Foothing & Column M50

0 Answers   HPCL,


brick work with 1:6 cement mortar how many bricks and cement and sand require for 1cum

3 Answers   Arma Group,


What Are The Different Type Of Slump Test Indications?

0 Answers   Bechtel,


suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?

0 Answers  


If the design mix of M-30 grade concrete is 1:1.5:2.8 (By Weight)& W/C ratio is 0.45, then what should be the volumetric mix for the same ?

3 Answers  


What are your future hopes for this job?

0 Answers   Jaycon,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5081)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4448)
  • Electrical Engineering Interview Questions Electrical Engineering (16620)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1093)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (258)
  • Instrumentation Interview Questions Instrumentation (2994)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (123)
  • Power Plant Engineering Interview Questions Power Plant Engineering (171)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1378)