Why we use Fuse in transformer in secondary side.Why we dont use fuse in primary side?
Answer / r n singh
The fuse size(14-36 swg) in the secondary side of the transformer is readily available in the market, whereas the fuse size for the use in the primary side ie in 11 kv will be very thick. It is very costly as well as not possible to use manually due to ever threat of electric shock. However, the AB switch is utilized in the primary side of the transformer.
Is This Answer Correct ? | 3 Yes | 1 No |
what is difference between electrical and electronics
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
What is the need for a controller?
What is meant by unilitrel device?plz tell about h-parametrs
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
What is the difference between PLC & DCS?
State nyquist stability criterion.
why do we prefer -48 volt instead of -24volt or -12 volt etc. ??
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
why ligthing is not available in switch yards?
how does high earth to neutral voltage affects electronic circuit?