why we use sinosidal voltage / current instead of others in
system?
No Answer is Posted For this Question
Be the First to Post Answer
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
what is meant by moulded case circuit breaker ?
Why X'mer rating in kva only?
what are symmetrical and non symmetrical components in electrical installation.
how can we minimize the off load losses of a distribution transformer which is required to be energized 24x7 ?? capacity of the T/F is 1250 KVA and off load losses are around 2.0 KW.. can we use capacitor bank at the secondary of such a T/F to overcome off load losses? please elaborate briefly...thanks
What is stub protection is all about?
why breaker closing coil gets burnt if supply is continously provided to it.
why alternator is used instead of dc generator and induction generator
What is the difference between air & vaccum circuit breakers?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
In scott connection why connect teaser transformer to 86.6% and main transformer to 50%..
Is there any abbrevation for STUB in Stub bus protection
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)